Moldex3D Flow/Pack/Cool/Warp (Anisotropic)

Test ID  
G-155

    
Description  
Properties needed to perform a Moldex3D full module analysis (injection-molding filling/packing/cooling/warping simulation) are generated. These include viscosity vs. shear rate at three temperatures (two in the processing range and one below); thermal properties and pvT data. Additionally, elastic modulus and thermal expansion coefficient are measured in two directions; Poisson’s ratio and in-plane shear modulus. Viscosity data are fit to Cross-WLF Model and PVT data are fit to the Modified Tait Model.    
Included Tests  
# Test Id Test Name
1x D-020 PVT (Isothermal Heating)
1x M-017 In-Plane Shear Modulus (Plate Twist Method)
1x M-101 Poisson’s Ratio and Tensile Modulus
1x M-102 Poisson’s Ratio and Tensile Modulus (2-3 Direction)
3x R-011 Capillary Rheology (1 Temperature)
1x T-015 Specific Heat
1x T-103 Thermal Conductivity Scan
1x T-302 Thermal Expansion Coefficient by TMA (Anisotropic)
 
Data  
Measured property data is provided. Material model files can be accessed directly from within Moldex3D by using your Matereality CAE Modeler ShowMe  
Samples  
1 - kg of pellets [?]
10 - plaques (4 x 12in) [?]
 		   
Application  
In addition to the information obtained from Flow/Pack/Cool analysis, Moldex3D Warp predicts the deformed shape and linear shrinkage of the part, estimates sink marks distribution, and calculates parts shrinkage and warpage.