C-MOLD Anisotropic Shrinkage for Semi-Crystalline Plastics
G-018
Description
Properties needed to perform a C-MOLD injection mold filling and packing plus shrink/warp simulation are generated. These include viscosity vs. shear rate at three temperatures (two in the processing range and one below); thermal properties, high cooling-rate PVT data. Additionally, the following mechanical properties are derived from tests on specimens cut from injection molded plaques; tensile modulus and thermal expansion coefficient in flow and cross-flow direction Poisson’s Ratio in 12 and 23 directions and in-plane shear modulus. Viscosity data are fit to Cross-WLF model and PVT data are fit to a Tait equation.
Included Tests
| 1x | D-023 | High Rate PVT by Hybrid PVT/DSC |
| 3x | R-011 | Capillary Rheology (1 Temperature) |
| 1x | M-101 | Poisson’s Ratio and Tensile Modulus |
| 1x | M-102 | Poisson’s Ratio and Tensile Modulus (2-3 Direction) |
| 1x | T-015 | Specific Heat |
| 1x | T-302 | Thermal Expansion Coefficient by TMA (Anisotropic) |
| 1x | T-103 | Thermal Conductivity Scan |
| 1x | M-017 | In-Plane Shear Modulus (Plate Twist Method) |
Samples
Application
In addition to all the capabilities of the C-Mold Post Filling program, this TestPak enables calculations of shrinkage and warpage. Recommended for semi-crystalline materials.
Add to Cart