Creep-Relaxation by DMA-tensile, compressive or flex
Creep tests are performed under constant load or stress conditions or short time intervals not to exceed 10 hours. These type of tests are performed by going to a load or stress point, then holding the load or stress value. The resulting increase in strain is recorded over time.
This test can be performed in tensile, compressive or flexural modes. The test can also be performed in relaxation mode under constant strain conditions. This usually involves going to a specific load or strain point, then holding the strain value. The
- DPL M-615
Creep displacement v. time, Creep Displacement v. Time. This data appears in Matereality as Tensile Creep.
Number of times this test is repeated: 1
2 flex bars [details]
This test is useful in material modeling simulations.