Moldex3D Flow/Pack/Cool/Warp (Anisotropic)

Test ID



Properties needed to perform a Moldex3D full module analysis (injection-molding filling/packing/cooling/warping simulation) are generated. These include viscosity vs. shear rate at three temperatures (two in the processing range and one below); thermal properties and pvT data. Additionally, elastic modulus and thermal expansion coefficient are measured in two directions; Poisson’s ratio and in-plane shear modulus. Viscosity data are fit to Cross-WLF Model and PVT data are fit to the Modified Tait Model.

Included Tests

1x D-020 PVT (Isothermal Heating)
3x R-011 Capillary Rheology (1 Temperature)
1x M-101 Poisson’s Ratio and Tensile Modulus
1x M-102 Poisson’s Ratio and Tensile Modulus (2-3 Direction)
1x T-015 Specific Heat
1x T-302 Thermal Expansion Coefficient by TMA (Anisotropic)
1x T-103 Thermal Conductivity Scan
1x M-017 In-Plane Shear Modulus (Plate Twist Method)



: 1 kg of pellets


: 10 plaques (4 x 12in)



In addition to the information obtained from Flow/Pack/Cool analysis, Moldex3D Warp predicts the deformed shape and linear shrinkage of the part, estimates sink marks distribution, and calculates parts shrinkage and warpage.

livechat button